
NANO-STAR'S TOP SELLER - NSC NANO WATERPROOFER

N S C
WORLD CLASS NANOTECH WATERPROOFING
NSC is our most popular waterproofing product to date. It is the best nano product for waterproofing in Singapore and globally.
HIGH PERFORMANCE NANO PARTICLES
HARD TO BEAT NSC
At our labs, we formulate the best suspension to create a stable product suitable even for heavy duty industrial use. Stringent lab practices allow NSC to function and perform at a much more stable and long lasting rate than other similar / nano products in the market.
Long story short - We found the best formula.
STELLAR RECORD
4 year performance warranty
NSC contains the clever and dynamic Titania Nanoparticle (NP).
Titania NPs are responsible for the incredible waterproofing property.




GREEN LABEL CERTIFIED
HDB MATERIAL LIST APPROVED


PRODUCT SPECIFICATIONS
Nano-Star NSC is a water-based liquid formulation. It provides effective waterproofing and surface protection for a wide range of building surface types.
With viscosity close to that of water, NSC nanoparticles (NPs) are able to penetrate deeply into capillaries that no other elastomer or polymer can. This nanotechnology based composition guarantees effectiveness, prolonged lifetime of coated surfaces and ZERO visible change to the original look / shine of the substrate.
While traditional waterproofing coats simply create a "film" over the substrate which is subject to weather, wear and tear, NSC NPs embed themselves deep into the pores without clogging up the substrate. This method of treatment makes it virtually impossible to be damaged or corroded. It cannot be removed via mechanical or chemical means.
Yet, due to the incredibly small particle
size, NSC treated surfaces remain
breathable. This is very important as
moisture will be able to escape from
inside relieving negative pressure to
prevent swelling, cracking and warping.
NSC treated surfaces are also
more UV resistant. This reduces the
"yellowing" effect of surfaces under
sunlight.

PHYSICAL PROPERTIES
Milky white, water emulsion with slight odour
pH: 7.1
Boiling & Flash Point: > 100 deg.
Auto Ignition Point: > 100 deg.
Density: 1.01 g.cm-3
Viscocity: 20mPa.s
NS Seal C is not considered an oxidant.
SAFETY & STORAGE
NS Seal C contains no hazardous ingredients and is water-based.
VOC Content: 0.7 g/L (well below limit)
Not hazardous at all.
APPLICATION
Surface should be dry and clean. Apply NS Seal C with a brush or spray. No dilution. On very absorptive surfaces reapply within 3 hours. Curing takes 8-24 hours.
MIXING WITH CEMENT
Replace 1/3 water with NSC during mixing of batch.
CONSUMPTION
10-15 sqm/L